NCC Product Home   Please Contact us for pricing

Q1D Series Series


Delay on Make
(Series Load)
Q1T Series

 
Logic Funtion
Logic Function Upon application of input voltage, the time delay starts. At the end of the time delay, the load is energized. Reset is accomplished by removing input voltage.
Note: The load may be located on either side of the line

 
Features
  • UR File #E65038
  • Solid-State Digital Timing
  • Compact Size
  • Superior Transient Protection
  • Flame-Retardant and Solvent-Resistant Polyester Thermoplastic Housing Polyester Thermoplastic Housing
  • 100% Life Tested
  • 20:1 Maximum To Minimum Timing Ratio
  • Low Cost
  • Epoxy Encapsulated
  • Trimpot On-Board with Sealed Cermet Element
  • Made in U.S.A.
Specifications
Time Delay
Adjustment: On-board trimpot
Range: 50 mS to 10 hours in 9 ranges
Repeatability: ±..5% + 8 mS maximum (0.25% typ) at constant temperature
Accuracy: Maximum time -0%, +10%
                    Minimum time -30%, +0%

Input
Operating Voltage: 12, 24, 120, 240 VAC/DC ±10% (On DC models, unfiltered supply voltage must be full-wave rectified)
Frequency: 50/60 Hz

Output
Type: Solid-state, normally open series load
Rating: Maximum Current -1 amp. AC/DC (resistive or inductive);
Life: 100,000,000 operations
Protection
Transient Voltage: Metal oxide varistor, (see ratings below)
Dielectric Breakdown: 3000 VAC, RMS, terminals to mounting
Isolation Resistance: 100 megohms minimum between terminals and case

Mechanical
Termination: .25" x.032" male fast-on terminals
Mounting: Surface mount with one #8 screw

Environmental
Storage Temperature: -40°C to 85°C
Operating Temperature: -40°C to 65°C
Humidity: 95% relative