NCC Product Home   Please Contact us for pricing

Q1D Series


Q1F Series
Delay on Make
(Series Load)

 
Logic Funtion
Logic Function Operating Logic: Upon application of input voltage, the delay starts. At the end of the time delay, the load is energized. Reset is accomplished by removing input voltage.
Note: 1) The load may be located on either side of the line; 2) Remote potentiometer leads should be shielded when running close to other wires; 3) The minimum time setting on external resistor-adjustable time delay relays is obtained by shorting together the external resistor terminals of the relay; 4) The maximum time setting within tolerance limits is obtained by using a 1 megohm resistor ; 5) Timing values between the minimum and maximum limits are linear with resistance within 10%; 6) Recommend 1/4 watt minimum resistor be used.

 
Features
  • UR File #E65038
  • 100% Life Tested
  • 20:1 Maximum To Minimum Timing Ratio
  • Compact Size
  • Flame-Retardant and Solvent-Resistant Polyester Thermoplastic Housing
  • Time Delays To 10 Hours Standard
  • Solid-State Digital Timing
  • Low Cost
  • Superior Transient Protection
  • Made in U.S.A.
Specifications
Time Delay
Adjustment: External resistor, factory fixed on special order (Minimum order requirement)
Range: 50 mS to 10 hours in 9 ranges increments.
Repeatability: ±.5% + 8 mS maximum (0.25% typ) at constant temperature
Accuracy:
         Maximum time ±2% at Rt = 1 megohms;          Minimum time +0%, -30% at Rt = 0 ohm

Input
Operating Voltage: 12, 24, 120, 240 VAC/DC ±10% (On DC models, unfiltered supply voltage must be full-wave rectified)
Frequency: 50/60 Hz

Output
Type: Solid-state, normally open series load
Rating: 1 amp. steady state maximum
Life: 100,000,000 operations 		Protection
Transient Voltage: Metal oxide varistor, see ratings below
Dielectric Breakdown: 3000 VAC, RMS, terminals
to mounting
Insulation Resistance: 100 megohms minimum
between terminals and case

Mechanical
Termination: .25" x .032" male fast-on terminals
Mounting: Surface mount with one #8 screw

Environmental
Storage Temperature: -40°C to 85°C
Operating Temperature: -40° to 85°C
Humidity: 95% relative