Have ever needed to solder something but the nearest power
outlet was too far away, out of reach, or not available? If so, then
the FX-901 cordless soldering iron is the perfect tool for you
The
HAKKO FX-901 is a lightweight, portable battery-operated soldering
iron. Powered by four AA alkaline or nickel-metal hydride (Ni-MH)
batteries, the FX-901 will operate above 600°F for up to 120
continuous minutes. No other battery-operated soldering iron can
deliver so much power for so many continuous minutes.
Other cordless soldering tools on the market spark,
which can damage sensitive electronic components, and butane can
ignite flammable vapors, causing serious injury or even death. But
the FX-901 is safe. No spark and no flame.
The FX-901 is the perfect tool for electricians,
field service technicians, maintenance personnel, hobbyists, artists
and home owners. Use it to solder electrical wiring, repair
appliances, alarm systems, RC cars and jewelry, anything that needs
soldering but electricity is out of easy reach or unavailable.
FX-901 Features:
• ON / OFF switch
• Quick-change composite tip (PN:
T11-B style)
• Maintains soldering temperature
of 600° F
• Separate battery magazine for
easy replacement of batteries
• Long-life battery power
• Alkaline batteries ~70 minutes
• Ni-MH batteries ~120 minutes
• Safety cap turns unit off and
covers tip
TIP REMOVAL
Turn the Nipple approximately 90° counter-clockwise to unscrew it
from the unit. Remove the Nipple and pull the tip out of the
connector.
TIP INSTALLATION
Insert the tip into the connector in the front of the iron. Place
the Nipple down over the tip and insert it into the unit by turning
it approximately 90° clockwise to screw it tightly on the unit.
CAUTION:
Before Inserting or Removing the Tip, turn the Power OFF. If the
tip is hot, allow it to cool down to room temperature. Never insert
a hot tip into the unit.
HOW TO USE
Turn the power switch ON. The LED will illuminate and the tip
will reach soldering temperature after 40 seconds. Be sure to turn
the switch OFF and attach the cap to the unit after use.
CHANGING THE BATTERIES
SLIDE the RELEASE LEVER on the back of the battery magazine down
to the UNLOCK position. Remove the battery magazine from the unit.
Insert four AA batteries into the magazine. Be sure to insert the
batteries in their proper polarity position (+ and -). Attach the
magazine to the unit by sliding it along the guide rails at the end
of the unit, then SLIDE the RELEASE LEVER up to the LOCK position.
Stop fussing with annoying wires and bothersome extension cords
once and for all. The FX-901 is a must tool for every tool box.
