It's a thermometer
The Fluke 16 measures temperature quickly and
accurately. Standard equipment includes an 80PK-1 bead probe thermocouple and an 80AK
temperature adapter, which is compatible with a wide range of type K thermocouples with
mini-connectors.
It's a flame rod circuit tester
A microamp function is included for flame sensor
measurements down to 0.1 microamps.
It's a multimeter with capacitance
Use the Fluke to test motor start and run capacitors
up to 10,000 microfarads. Rely on the Fluke 16 to make your everyday measurements - up to
600 volts ac or dc, 40 megohms, diode test and exceptionally fast continuity.
Accurate temperature measurement from -40 to 750
degrees F (-40 to 400 degrees C)
Confidently test flame sensor circuits with microamp
measurement down to 0.1 microamps
Capacitance up to 10,000 microfarads
Min/Max recording with relative time stamp records
the highest and lowest voltage readings during a 100-hour period
Auto-ranging
High resistance ranges to 40 megohms
Millivolt range for compatibility with other
accessories
V-Check™ mode is designed for safety. When
measuring ohms, continuity, or diode test modes, the meter automatically switches to
measuring ac or dc volts if more than 4.5V is present
Continuity Capture™ locates intermittent opens
as brief as 250 microseconds and identifies them in a symbolic display as short-to-open or
open-to-short
Sleep mode preserves battery life
4000 count digital display
Meter includes: 80PK-1 Bead Temperature Probe, 80AK
Temperature Adapter, TL75 Test Leads, and C10 Holster
Safety
600V ac/dc, maximum voltage between any terminal and earth ground. Conforms to the
requirements of IEC-1010-1, 1990-09 and ANSI/ISA-S82.01-94 for use in Overvoltage Category
III locations. Make ac or dc voltage measurements on electrical distribution systems to
600V where transients do not exceed 6 kV and only on circuits limited to 14 kVA if the
circuit voltage rating is above 250V. Certification agencies (approvals/listings pending):
UL
Per standard UL 3111
CSA
Per standard CSA/CAN C22.2 No.1010.1-92
TÜV
Per standard EN61010 Part 1-1993
Drop test
ANSI/ISA-S82.01-94 and EN61010 Part1-1993. 10 ft. drop
to hardwood on concrete
Size
(HxWxL) 1.12" x 2.95" x 6.55", (2.8 cm x 7.5 cm x 16.6 cm)
¹ The 4000 mV range can only be entered in manual
range mode.
Use the 4000 mV range with accessories.
² The accuracy specification is for capacitors
that have negligible dielectric absorption.
Capacitance measured with rc charge technique that evaluates C = Q/V. Capacitors
with non-negligible dielectric absorption can be measured but measurement values
may be in error.
³ Temperature accuracy specifications do not
include the error of the thermocouple.
